Payment & Shipping Terms:
|Gender:||Male||Application:||Audio & Video|
|Material:||Zinc Alloy||Product Name:||Electrical Connector|
TRS Microphone Connector Z-NP3X Digital pull and push audio jack connector 6.35mm
The jack plug at the top is a TS jack. The pointed metal bit at the end, is logically enough, the tip, and the long metal shaft is the sleeve. The black band between them is an insulator preventing the two parts of the jack from shorting together. Notice we said ‘band’ and not ‘ring’. It’s easy to look at a TS jack and assume the black insulation ring is the ‘R’ in TRS but it’s not. The TRS jack is at the bottom. It has a metal ring in the middle which is the third conductor. The three conductors are separated by two black insulation bands.
There are other types, most commonly a TRRS which has two rings, and four conductors in total. TRRS jacks are often used for stereo headsets with microphones where four conductors are needed for ground, left channel, right channel, and mic.
*100% open & short test
*Hi-Pot: DC 300V 10ms
*Insulation Resistance: 10M OHM /300V Min.
*Contact Resistance: 0.01 OHM Max.
*Shield up to 65% braid.
*Working Temperature: -25℃ ~ +85℃
A stereo/TRS (short for Tip/Ring/Sleeve) 1/4-inch plug looks like an analog stereo headphone plug. The tip is the end of the plug, the ring is the small middle section located between the two plastic dividers, and the sleeve is the rest of the metal part of the plug. A TRS plug can be used for the following three types of cords:
Stereo cord: A stereo cord is used for signals that contain two separate portions: one for the right channel and the other for the left channel. This type of cord is generally wired with the left-channel signal attached to the tip, the right-channel signal connected to the ring, and the shield wired to the sleeve. This type of cord is typically used for headphones.
Balanced cord: A balanced cord is used on professional audio gear to join the various pieces of equipment (to connect the mixer to the recorder, for example). The advantage with a balanced cord is that you can have longer cord runs without creating noise.
Why are balanced cords so conveniently noise free? The balanced cord has two wires and a shield inside and has the same signal running through both wires.
One signal is 180 degrees out of phase with the other (that is, their waveforms are opposite one another), and when the signals get to the mixer (or whatever they’re plugged into) one of the signals is flipped and added to the other. When this happens, any noise that built up in the signal is canceled out.
Y cord: A Y cord consists of a TRS plug on one end and two TS plugs on the other, forming — you guessed it — a nice representation of the letter Y. This cord allows you to insert an effect processor — a compressor or equalizer, for example — in the line of a mixer (more specifically, into the insert jack of the mixer).
|Over mold||PVC 70Pa UL94V-0 Black|
|Pre mold||PE Low Density|
|Insertion Force||35 N Max|
|Withdraw Force||10 N Min|